• Model NO.：Water jet cutting machine
• Power Source：High Pressure Pumps Water Jet Cutting Machine
• Style：Gantry
• Type：Three-Axis
• Ceramic：Ceramic Water Jet Cutting Machine
• Glass：Glass Water Jet Cutting Machine
• Metal：Metal Water Jet Cutting Machine
• Plastic：Plastic Water Jet Cutting Machine
• Stone：Stone Water Jet Cutting Machine
• Crystal：Crystal Water Jet Cutting Machine
• Rubber：Rubber Water Jet Cutting Machine
• Transport Package：Foam Plastic Inside, Wooden Case out Side
• Specification：2030 water jet cutting machine
• Trademark：FINEWORKCNC water jet cutting machine
• Origin：China Water Jet Cutting Machine
• HS Code：8208900000
• Production Capacity：100

Detailed Photos

    

   
    

1.   Product ParametersApplication

   Installation Instructions

   Consume spares

   Our Advantages

   FAQ

   Common failure analysis
   1. There is no high pressure and low pressure, but the commutation is normal.
   (1) Check whether the tap water supply is cut off or the water pressure is too low;
   (2) Check whether the water pump is normal;
   (3) Check whether the jewel nozzle is normal (the water jet diverges obviously);
   (4) Check whether there is oil leakage or water leakage in the peep hole after the baffle plate (water leakage indicates that the dynamic seal of the high pressure chamber is damaged; oil leakage indicates that the dynamic seal of the cylinder baffle plate is damaged.);
   (5) Check whether the water inlet check valve is invalid (the water inlet pipe has obvious return water);
   (6) Check whether the water outlet check valve is invalid (the hand feels obviously hot at the check valve);
   (7) Check whether the high-pressure plunger rod is broken (remove the inlet and outlet pipes and the water outlet check valve, insert a thin steel wire into the high-pressure cylinder, probe the plunger rod, turn on the motor oil pump, and observe whether the steel wire is ejected. No top If the moving distance is small, it indicates that the plunger rod has broken).
   1. There is no high pressure or low pressure, and the commutation time is too long or no commutation:
   (1) If the direction is not changed and the oil pressure is high, push the solenoid valve stem at either end of the direction change valve by hand;
   (2) Adjust the position of the Hall switch (slightly move the Hall switch towards the cylinder);
   (3) Check whether the reversing Hall switch is normal;
   (4) Check whether the electrical part of the reversing valve is normal, and confirm whether the flow rate of the oil pump has been adjusted (too small);
   (5) Confirm whether the flow rate of the overflow valve has been adjusted (too much);
   (6) Check whether the spool of the reversing valve is blocked or worn;
   (7) Check whether the piston seal in the oil cylinder is damaged